For Immediate Release: Contact: Beth Weaver (301) 814-4088 February 18,, 2015 beth_weaver@verizon.net Safety Advocates Call on U.S. DOT to Issue Rule Requiring Crash Avoidance Technology for Large Trucks As Deaths and Injuries from Truck Crashes Continue to Rise, Federal Regulators Must Require Lifesaving Technology in All New Large Trucks WASHINGTON, D.C. – Advocates for Highway and Auto Safety, the Truck Safety Coalition, the Center for Auto Safety and Road Safe America, filed a petition today with the National Highway Traffic Safety Administration (NHTSA) requesting that the agency initiate rulemaking to require forward collision avoidance and mitigation braking (F-CAM) systems on all new large trucks and buses with a gross vehicle weight rating (GVWR) of 10,000 pounds or more.

F-CAM technology uses radar and sensors to first alert the driver and then to apply the brakes when a crash is imminent. F-CAM systems employ a Forward Collision Warning (FCW) to alert a driver when his/her vehicle gets too close to another vehicle that is stopped or traveling more slowly in front of his/her vehicle, giving the driver a chance to brake. When the system determines that a crash is about to occur, a Collision Mitigation Braking (CMB) system automatically applies the brakes to avoid the crash or reduce its severity. NHTSA estimates that current generation F-CAM systems can prevent over 2,500 crashes each year and future generation systems could prevent over 6,300 crashes annually. However, the agency has not yet decided to move ahead to require this basic crash avoidance technology.

“The safety technology is available to reduce the carnage on America’s roads resulting from rear-end crashes by large trucks,” said Henry Jasny, Senior Vice President of Advocates for Highway and Auto Safety. “The NHTSA can take action to improve safety and reduce preventable losses by requiring F-CAM technology on all large commercial motor vehicles.”

Truck crashes are a serious public safety threat. Every year on average, over 4,000 people are killed and nearly 100,000 are injured in crashes involving large trucks. Since 2009, the number of fatalities resulting from collisions involving large trucks has risen 16 percent and injuries have increased by 40 percent. The annual cost to society from crashes involving commercial motor vehicles is estimated to be over $99 billion. According to NHTSA data, from 2003-2008, there were 32,000 crashes involving a truck striking the rear of a vehicle resulting in at least 300 fatalities and injuring over 15,000 people annually. However, since 1,600 large trucks are involved in fatal crashes in which the front end of the truck is the initial point of impact, the annual death toll in this crash mode may be far higher than 300 deaths each year. These crashes are precisely the type of collisions that F-CAM technology can prevent.

John Lannen, Executive Director of the Truck Safety Coalition commented, “In work zone areas and when traffic is significantly slowed or at a complete stop, cars are particularly vulnerable to being rear ended by large trucks. Trucks are overrepresented in fatal highway crashes, and they are even more so in fatal work zone crashes. This is why it is imperative that F-CAM technology is required safety equipment in large trucks.”

With total tonnage of truck freight shipments predicted to increase by as much as 63 percent by 2040, the need for F-CAM technology has never been greater. While nearly every truck manufacturer currently offers some type of F-CAM system on new vehicles, there is no national standard for F-CAM system performance and not all buyers purchase this safety option. Thus, few trucks are actually equipped with the technology despite its availability. Only 3 percent of the more than 3 million standard tractor-trailers (class 8) on the road today are equipped with some form of this technology.

Steve Owings, Road Safe America Co-Founder and immediate past Chairman of the Motor Carrier Safety Advisory Committee, lost his son, Cullum, when the car Cullum was driving was barreled into from behind, in stopped traffic, by a tractor-trailer. That big-rig’s driver was speeding 8 mph over the posted speed limit using cruise control and didn’t touch his brakes until his truck was within 100 feet of the stopped traffic. “There is little doubt that Cullum would still be alive today if only that truck had F-CAM technology,” Owings said.

Judith Williams, of Merrillville, Indiana, whose daughters, Lindsey and Yvette Williams, grandchildren, Yazmin and Arielle Goldman and Jamin and Jazmin Osborne, and brother, Amado Mangual, were all killed in a truck crash last year in Jasper County, Indiana, stated, “I was devastated after I learned technology already exists that could have prevented my family’s crash.” The crash that killed Judith’s family occurred when a truck rear-ended their SUV in slowed traffic approaching a work zone area. Judith continued, “I know nothing I do will bring back my loved ones, but I will work to ensure that no one else has to go through the tremendous loss and heartache my family and I must cope with for the rest of our lives.”

Federal regulatory action has previously expedited the installation of critical vehicle safety advances, such as airbags and Electronic Stability Control (ESC) systems, by requiring these safety systems as standard equipment rather than as expensive options. Federal regulation remains the best and swiftest means to ensure the latest safety advances reach the majority of the traveling public.

Jane Mathis, lost her son David and David’s bride of five days, Mary Kathryn, when a truck driver fell asleep behind the wheel and rear ended their car which was stopped in traffic. Mathis, a board member of Parents Against Tired Truckers (P.A.T.T.) and a member of the Federal Motor Carrier Safety Administration Motor Carrier Safety Advisory Committee (MCSAC) stated, “David and Mary Kathryn might be alive today if F-CAM had been in use at the time of their crash. Every moment that NHTSA neglects to issue a rule, they miss an opportunity to keep a family whole.”

“Many hundreds of lives could be saved each year if trucks are equipped with automatic braking systems,” said Clarence Ditlow, Executive Director of the Center for Auto Safety. “The NHTSA should move quickly to require this safety technology on all trucks.”

Read the petition here:

Petition for Rule Making (PDF)

Petition Crash List (PDF)

Press Release (PDF)